New Capability- Rubber repairs

Following our visit from the FAA we are pleased to be able to add injection rubber to our list of capabilities. We are now able to support our customers with the repair of sacrificial rubber in the inlet housing , which is part of the Sumitomo pneumatic engine starter. This component is found on the…

Metal 3D Printing

In partnership with UMass we will be sending two of our employees on a tailor made metal 3D printing course hosted by UMass at their Amherst Life Science Lab. This course will allow us to better understand the application of this technology and provide us with the opportunity to produce metal parts for our production…

Pneumatic Starter inlet housing

As part of our increasing capabilities we are now in the development and new part introduction process for the rubber repair of the inlet housing. These parts are found in the pneumatic engine starter manufactured by Sumitomo and Hamilton Sundstrand typical models PS700, PS600 and PS400. Our first repair capability will be to perform the…

3D Printing – Hybrid Inspection fixture

Building on our experience and working relationship with UMass we have developed a holding fixture using 3D printing technology for our CMM inspection process. This ring allows us to perform inspections of both the front and rear of the part. Using the speed advantage of 3D printing from design to use in less than three…